Pipe Relining

Inspect and measure the pipes

Our specialist plumber sends the camera down to assess the plumbing system to find any breaks and pipe blockages, and measure up. This identifies what the problem is and where it’s situated.

Our certified technicians create a custom pipe lining and bladder

Once we have the confirmed measurements, a custom felt liner and an inflatable bladder is created to match the exact specifications of the pipe, including any bends or junctions.

We install the pipe relining solution

When we’re ready to install the relined section of pipe, the felt liner is soaked in an epoxy resin, and the uninflated bladder is inserted into the pipe liner. A rope is attached to each end of the liner, which is used to pull the pipe liner into place by using the existing access points to your pipes.

Using a specialist drain camera, the correct position is identified and the bladder is inflated with air, which blows out the felt liner to seal against the existing pipes, creating a new pipe that holes up any breaks or cracks. The bladder remains inflated until the resin has cured to create a hard, tough pipe., leaving a brand new, tough and watertight pipe.

The relined section is tested and commissioned

Once your pipe has been relined, we use our CCTV drain inspection camera to check that everything has been installed and sealed correctly.

Different types of pipes need a different type of epoxy resin solution. JetBlack will work with your site specific requirements for different environmental factors, from pressurized pipe relining to sewer pipe relining.